Digital light intensity sensor module

Model: GY-302.
Digital brightness sensor module.
The module is based on the BH1750 chip, it has a 16-bit analog/digital converter (ADC), which means that its output signal is in digital form with the I2C protocol, which allows a simpler interaction between the sensor and the Arduino or Rapsberry with which you are going to work.
The applications that can be given to this module range from light intensity control for screens or home automation, as well as ambient light measurements.
Features:
Operating voltage: 3 V to 5 V.
Digital interface via I2C bus with the ability to select between 2 addresses.
Spectral response similar to that of the human eye.
Perform illuminance measurements and convert the result to a digital word.
Wide measurement range 1-65535 lux.
Low power consumption mode.
Noise rejection at 50/60 Hz.
Low dependence of the measurement against the light source: halogen, LED, incandescent, daylight, etc.
The influence of the infrared spectrum is little.
Size 13.9 X 18.5 mm.