GY-NE06MV2 / GY-GPS6MV2 GPS module with EPROM APM2.5 & APM

Model: GY-NE06MV2 / GY-GPS6MV2.
Input Supply Voltage Range: 3.3V-6V, on board voltage regulator maintains 3.3V
I/O Maximum Logic Level: 3.6V
We have tested it with direct connection to the 5V serial pins on an Arduino and found it to work fine but extended periods of time may be different
To use with a 5V logic device, such as an Arduino, we suggest level shifting the 5V TX signal using one of the following:
Two 1N4148 diodes in series between the TX pin on your 5V device and the RX pin on this GPS module (will drop voltage to ~3.6V)
Only recommended for baud rates of 9600 and less
Use a logic level converter module such as the Addicore Bi-Directional Logic Level Converter
WAAS (Wide Area Augmentation System) enabled GPS unit
<1 second to first fix (TTFF) for hot starts
27 seconds to first fix (TTFF) for cold starts
On board LED will blink after module acquires a position fix and will continue blinking as long as the module has a fix
50 Channel NEMA GPS receiver
UART: 9600 baud by default, but is configurable from 4800 to 115200 baud
5Hz max update rate
External EEPROM for configuration storage
Four plated mounting holes, 3mm in diameter
One additional non-plated mounting/antenna cable hole, 4mm in diameter
Position Accuracy: 2 m and better with multiple good satellite signals
Velocity Accuracy: 0.1 m/s
Maximum Velocity: 500 m/s
Heading Accuracy: 0.5 degrees while moving
On board battery for battery backed RAM (BBR)
Battery is recharged through a simple diode and resistor charger circuit from the on board voltage regulator's 3.3V output
Three different power modes (refer to Receiver Description Including Protocol Specification for information on configuring the operating mode)
Two continuous operating modes:
Maximum Performance Mode - continuously uses the acquisition engine, resulting in the best possible time to first fix (TTFF)
Eco Mode - optimizes the use of the acquisition engine to minimize current consumption
One intermittent operating mode
Power Save Mode - draws only 11mA - Utilizes cyclic tracking, with configurable update periods, which reduces the average power consumption significantly
-156dBm Hotstart sensitivity
Weight: 17.6g
Dimensions of GPS Module: 36mm x 25.8mm x 4mm
Dimensions of Antenna: 25.5mm x 25.5mm x 8.8mm